Once again, I soak the bones.
I start by drilling a hole in the humerus and scapula where they meet. Make sure that the holes are in the right angle!
I then work on the harder things:
drilling in the metacarpals and the phalanges.
I decided to not include the carpals (wrist bones) because I only have a few of them and it is very hard to find exactly where they go.
Here's the name of the fingers, in this case in a human hand:
In most animals, the distal phalanges are the 'claw bone'
I started with the metacarpals.
Drill a hole in both ends of the bone. it works better if you just drill through the bone (so it makes a 'tunnel'), but I could not because the drill bit was too big. (I used a 1.5 mm drill bit)
Then, I cut the wire that will connect the metacarpals to the radius pretty long ..maybe 7 or 8 centimeters so it'll be easier to tie the fingers together later on. I glue that wire. (To help distinguish between the 2 forearm bones : the radius is thicker then the ulna whilst the ulna is longer. The ulna has a 'hook' at one end which connects with the humerus.)
I drill a hole on both ends of all the metacarpals, and proximal phalanges. (I only drill into one side of the intermediate phalanges)
I put wire like this
(the proximal phalanges and intermediate phalanges are already glued)
I then glued the intermediate phalanges to the distal phalanges (claw bones)...
and glue the metacarpals to the proximal phalanges.
I now have 4 fingers and a leg.
So, I must attach all the fingers to make a hand or paw.
here are the steps I took to attach the fingers:
this is what the completed paw looked like: